Operations log WPC
(A) Startup date with transfer log
Plant type: 1.024-
Startup date:
Type of raw water source:
Operating hours display [h]
Flow rate of raw water [µS/cm]
Raw water temperature [°C]
Media filter of inlet pressure during plant running
[MPa]
Active carbon filter of inlet pressure during plant run-
ning [MPa]
Inlet pressure of fine filter [MPa]
Pump pressure [MPa]
Membrane input pressure [MPa]
Drinking water quantity [l/h]
Yield [%]
Dosing pump flocking stroke/ frequency [%]
Dosing pump anti-scalant stroke/ frequency [%]
Remarks
Confirmation: The plant was started up and handed over in a fully functioning condition. It has been explicitly brought to the notice of
the customer that the watre produced by the plant must be checked according to the local standards by an approved testing agency
before releasing it as drinking water. Further, it has also been brought to the notice of the customer that the operations log is to be
maintained; the customer has also been informed about the risks involved in handling chemicals and the hazards on account of inter-
changing the chemicals.
Place, Date, Signature (Customer)
20
English
Plant number:
Installation site:
Customer:
Raw water hardness [°dH]
pH value fo raw water [pH]
Media filter of inlet pressure during return rinsing [MPa]
Active carbon filter of inlet pressure during return rinsing
[MPa]
Outlet pressure of fine filter [MPa]
Concentrate pressure [MPa]
Concentrate quantity [l/h]
Drinking water flow rate [µS/cm]
Dosing pump pre-chlorination stroke/ frequency [%]
Dosing pump post-chlorination stroke/ frequency [%]
Place, Date, Signature (Kärcher Service)