Vertiv GEIST Guía De Instalación Rápida página 2

VERTIV GEIST UPGRADEABLE PDU GU2
TM TM
Quick Installation Guide
Geist UPDU Electrical Ratings
INPUT RATING
CURRENT (MAX)
24 A 200
40 A
VAC, 3W+PE
200
24 A (UL) / 32 A
(CE)
48 A
24 A
100
16 A
48 A (UL) / 63 A
(CE)
48 A
24 A (UL) / 32 A 100
(CE)
Configuring IP Addressable
Units
The PDU is equipped with an RJ45
Ethernet port for connection to an
existing network. The PDU is
configured with the following default
network settings to allow unit
configuration:
• IP address: 192.168.123.123
• Subnet Mask: 255.255.255.0
Gateway: 192.168.123.1
The local PC network connection must
be configured as follows:
• IP Address: 192.168.123.x (where x
is 2-253, except 123)
• Subnet Mask: 255.255.255.0
• Gateway: <leave blank>
2
VM1246/SL-70646_REVA_09-20
VOLTAGE FREQUENCY
to 240 VAC 50/60 Hz
200 to 240
50/60 Hz
to 240/346-
415 VAC, 50/60 Hz
3W+N+PE
100 to 240
50/60 Hz
VAC
100 to 240
50/60 Hz
VAC 3~
to 240/208–
50/60 Hz
415 VAC 3~
100 to 240
50/60 Hz
VAC
100 to 240
50/60 Hz
VAC 3~
to 240/208–
50/60 Hz
415 VAC 3~
TO REPLACE THE IMD
MODULE:
I
MPORTANT: Photos for these steps
are shown on page 3.
NOTE: Be sure to have the new IMD
module ready for installation
immediately after removal of the old
IMD.
1. Remove the disposable ESD wrist
strap from the package, remove
the adhesive backing and attach
the strap to the PDU. Put the wrist
strap on your arm so that it has
contact with bare skin.
2. Insert the Vertiv IMD Removal Tool
as shown. Be sure to press the tool
in level, pressing in until the tool is
flush with the face of the IMD.
Some older versions may require
overlays to be removed prior to
inserting the tool.
FACILITY SIDE # OF CIRCUIT
CABLE BREAKERS
Single-
Phase
4-wire Delta
5-wire WYE
Single-
Phase
4-wire Delta
5-wire WYE
Single-
Phase
4-wire Delta
5-wire WYE
3. Carefully pull the tool and the IMD
straight out about 2 inches.
Remove the tool from the IMD.
CAUTION: The IMD is still
connected internally. Do not pull it
more than 2 inches from the
chassis.
4. Gently unplug the connector from
the IMD.
I
MPORTANT: . Ensure that you have
the wrist strap on before proceeding.
See Step 1 for more information.
5. Connect the cable to the
replacement IMD module.
6. Place the cable into the strain-
relief slot in the IMD's housing as
shown.
7. Tuck the excess cable back into
the PDU, and slide the IMD straight
in. Press with both
the IMD snaps into place.
PANEL MOUNT
CONNECTOR
6
6
7-wire, 3 inch
6
3
3
3
6
8-wire, 1.5 inch
6
6
thumbs until