goliath G-P1 Manual Del Usuario

EN
GOLIATH G-P1
USER'S MANUAL
BASE WITH WHEELS FOR GOLIATH PRO+
WHAT YOU WILL FIND IN THE BOX:
2 wheels with brakes
2 normal wheels
4 Allen screws 8x12mm
4 height adjustable plugs
7 Allen screws 8x16mm
2 front legs
1 small back leg
DESCRIPTION AND TECHNICAL CHARACTERISTICS:
The Goliath G-P1 base was designed to have a mobile alternative for using the Goliath Pro
electric stand. Designed for smaller spaces where it is not possible to anchor the stand to
the ground, the wheeled base allows you to easily move the stand regardless of its weight
, even with a bicycle attached to it.
Height adjusting plugs are also included in case the user prefers to keep the stand xed
but without anchoring it to the ground.
ASSEMBLY AND USE INSTRUCTIONS:
ASSEMBLING THE FEET IN THE GOLIATH PRO SUPPORT:
1- The G-P1 feet are exclusively designed for the Goliath Pro + stand and cannot be used on
any other stand in the Goliath Bike line.
2- Present the two front feet on the oor and mount the stand on them in such a way that
the 6 holes in the base of the support coincide with the holes in the feet. (Photo 1)
3- Fix the stand to the feet by screwing the 6 included 8x16mm Allen screws. (Photo 2)
4- Tilt the stand forward letting it rest with the clamp against the ground to access the
bottom of the feet.
*FOR NO REASON TILT THE SUPPORT BY THE ENGINE AS IT IS FRAGILE AND MAY BE
DAMAGED BY THE WEIGHT OF THE SUPPORT.
5- Fix the rear leg to the base of the stand with the remaining 8x16mm Allen screw and the
four wheels with the 8x12mm Allen screws, so that the two wheels with brakes are in the
front. (Photo 3)
6- Reposition the stand tilting it towards its original position.
7- Use the stand with the two front wheel brakes activated, and deactivate them only to
move the stand.
8- In case you want to mount the feet with regulating plugs, simply x the plugs by
screwing them at the bottom of the feet.
DANGER WARNINGS IN THE USE OF G-P1 WHEEL BASE:
1- Due to the excessive combined weight of the Goliath Pro stand and the G-P1 base with
wheels, it is necessary to mount with extreme caution and preferably between two people.
It is also very important to take care not to damage the stand during the mounting of the
feet, avoiding using the casing or the motor as support points, since they could permanent-
ly damage its operation.
2- We recommend that this component be used only by adults.
MAINTENANCE:
1- The feet with wheels do not need any speci c maintenance.
2- In case of obstruction of the wheels it will be necessary to check if they have been stuck
with any element.
Photo 1
Photo 2
Photo 3