URBANGLIDE Quad 4.0 Manual Del Usuario página 10

CAUTION: Turn off the quad before handling the following parts.
Replace the chain (15min)
1. Remove the bolt from the right rear
wheel with the 6mm hex wrench.
4. Remove the part holding the chain
(A) and slide it to remove the chain
completely.
7. Retighten the nut on the wheel axle
using the 5mm hex wrench and the
10mm wrench.
Maintenance and reparation
2. Remove the nut on the wheel axle
using the 5mm hex wrench and the
10mm wrench.
5. Remove the part holding the chain
and slide it to remove the chain
completely.
8. Tighten the bolt on the middle of the
wheel with the 6mm hex key.
3. With the screwdriver, unscrew the 3
screws on the protective casing of the
chain.
6. Screw on the protective housing
using the 3 screws.
10