Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe Mediano II Instrucciones De Montaje



Safety Notes

Gloves should be worn during installation to prevent

crushing and cutting injuries.
The shower system may only be used for bathing,

hygienic and body cleansing purposes.
The hot and cold supplies must be of equal pres-

sures.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.

Technical Data

This mixer series-produced with EcoSmart
limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 157 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe mixers can be used together with hydrauli-
cally and thermically controlled continuous flow heaters
if the flow pressure is at least 0,15 MPa.
4
English

Symbol description

®
(flow
®
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 10
Do not use silicone containing acetic acid!
To adjust the hot water limiter on single lever
mixers, please see page 12. No adjustment
is necessary when using a continuous flow
water heater.
Dimensions (see page 13)

Flow diagram

(see page 13)

with EcoSmart
®

without EcoSmart
®
Operation (see page 14)
Cleaning (see enclosed brochure)
Spare parts (see page 16)
Special accessories
special tool (58085000) order as an extra
Installation kit order as an extra
Test certificate (see page 15)