Before Welding - GYS GYSMATIC 9.13 Manual De Instrucciones

EN
The welding helmet GYSMATIC LCD 9/13 G complies with EEC directives 89/686 CEE. This confirmity is established in compliance with EN 175, EN 166, EN 168 and EN 379.
Notified bodies / organisations :
Cell :
Identification number : 0196
This welding helmet is delivered ready for use. For your protection, please read carrefully these instructions and consult with a qualified instructor prior to operation.

BEFORE WELDING

-Check that the welding helmet is in good condition and headband adjustment.
-Check whether the front cover lens, the front frame and filter are inserted and fixed in place. In case of anomalie, please proceed to its reconditionning.
-Make sure that the 4 sensors (9) and the cell (8) are not obstructed by dust or debris.
-Make sure that the protection films on both screens are removed.
-Make sure that the red light (1) is off, otherwise change the batteries (7).
-Check that the protection level matches your welding processes. Please refer to the following chart to help your choice (cf. welding process board)
OPERATION
The GYSMATIC LCD 9/13 G auto-darkening welding helmet switches from light to dark state when a welding arc is struck. The auto-darkening welding helmet switches back
to the light state when the arc stops.
1 2 3 4 5
6
7 7
Shade potentiometer : The shade number can be set manually between Din 9 à 13. Select a shade number by the internal knob.
• Internal sensitivity potentiometer : Sensitivity adjustable according to :
- Light ambient: Without welding, turn the sensitivity setting towards «max», then turn the sensitivity setting towards «low» until filter lightens.
- Welding process: «Max» position for low amperage TIG rpocess / Medium range for most application.
• Internal delay potentionmeter: Controls the delay for the helmet to switch back to clear after welding.
Delay is designed for slower switching time to clear state to eliminate remained bright rays.
• The Low battery indicator blinks when the battery replacement is required. (2 coin type CR 2450, 3V).
• "WELD/GRIND" knob : For non-welding operation, you can switch off the filter on « Grind » mode. The Grind led will blink to confirm the filter is off.
WARNING: To be protected before welding, carefully check the switch to be on WELD mode.
PRECAUTIONS
• The welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas welding.
• Standard protective screens must be installed on both inside and outside surfaces of the module. Failure to use protective screens may constitute a safety hazard or result in
irreparable damage to the module.
HEADBAND ADJUSTMENT
The GYSMATIC LCD 9/13 G is equipped with a headband which can be adjsuted in multiple ways to suit the welder: width, height (1), longitudinal inclination (3) and adjust-
ment (2).
Welding hood / Protection
screen :
1. Low charge leve
2. Shade control knob
3. Sensitivity control knob
8
4. Delay time control knob
5. Potentionmeter «Welding-Grinding»
10
6. LCD protection plate
9
7. Lithium batteries (CR2450)
8. Solar cell
9. Sensors
10. Filter
Clear shade 4
Dark shade 9-13
Filter dimension 114x133x9mm
Reaction speed 0,00008 s
Power supply Solar + batteries
Weight 4580 gr
Field of vision 100x60mm
Applications MMA 5>400A / TIG 5>250A / MIG-MAG 5>500A / Grind
Warranty 1 year
Application temperature -10°C / + 55°C
Storage temperature -20°C / + 70°C
Identification number : 0196
5