Instructions For Assembly - DDUUEETT COINFYCARE LOMI EL05 Manual Del Usuario

If the electrical supply cable is defective, disconnect
the table immediately and inform your dealer or a
specialised technician.
Position the power cord properly so that it cannot be
tripped over.
Unplug the power cord from the mains if the table is
not going to be used for a long period of time.
If you detect any abnormality in the operation of the
table, consult your dealer or a specialised technician.
Never manipulate any electrical part or open or repair
any part of the table.
Only your dealer or a specialised technician should
repair the table.
Never touch the table or the power cord with wet
hands.
Never place your hands or any other part of your body
in any hole or void on the table while it is in operation.
Make sure there are no objects in the space under the
table that could cause collisions or entrapment during
the movement of the same.
Make sure that your feet are not resting on the
peripheral foot bar during treatment and especially
when sitting near the table. This could create a
dangerous situation where your leg is caught between
the section and the peripheral foot bar.
Take into account the weight distribution on the
table when working. The weight must be distributed
along the table without concentrating on its ends to
maintain the correct stability of the same.
You should not sit on the head and foot sections. If
you do, there is a danger of tipping.

INSTRUCTIONS FOR ASSEMBLY

Place the paper roll holder in the position indicated
in the image below. Tighten the 2 locking knobs until
secure.
PLACEMENT IN THE WORKPLACE
The table has 4 wheels to facilitate its movement to
the place where it will be used.
Once correctly positioned, the table has an
immobilisation system that prevents it from moving
during use.
To activate or deactivate this system, you must press
either of the two levers with your foot, as shown in the
following images.
- Image 1: Table in working position.
- Image 2: Table in position for movement.
OPERATIONS
Connect the bed to an electrical outlet using the
power cord.
Motor functions
- Peripheral foot bar for height adjustment
• Before adjusting, make sure there are no objects
in the space below the table that could cause
collisions or entrapment.
• Press the peripheral foot bar with your foot to one
side or the other to adjust the height of the table.
- Foot control for adjusting the central section
• Use the foot control to adjust the inclination of
the central section of the table. With this, it is
possible to place the table in the Kyphosis and
Trendelenburg positions.
EN
3