Maintenance Information - nania D12 Manual De Instrucciones

Installing the car seat in a front-facing position (Gr. 2, from 15 to 25 kg)
Make sure that you have removed the harness of the car seat before starting the installation. Follow the
instructions in the section entitled 'Removing the harness'.
Place the car seat in a front-facing position on the rear passenger seat of your vehicle and sit your child in the
car seat. Pull on the seat belt until it is completely loose. Thread the seat belt through the openings on the side
of the shell and cover of the car seat (31). Pull on the belt and threaded through the openings on the opposite
side of the shell and cover (32). Fasten the seatbelt (33). On the side nearest the belt winder, pull up the diagonal
belt through the slot located on the side of the shell (34). Place the car seat so that only the front of its base is in
contact with the seat of the vehicle (35). Make sure the belt is not twisted and pull it as tightly as possible (36).
Check that the diagonal lies across your child's shoulder, clear of their neck.
IMPORTANT: once the car seat has been installed, the vehicle seat buckle must not touch the opening through
which the belt passes on the side of the car seat. If it does, choose another place in the vehicle. If in doubt, please
contact our customer service department.
Storing the instructions
Keep these instructions to hand, by sliding them between the cover and the shell of your car seat (37).

Maintenance information

All the fabric parts are removable. To take off the cover, first remove the harness following the instructions in the
section entitled 'Removing the harness' (38).
Minor stains can be cleaned using a sponge and soapy water or hand-washed at 30° in soapy water. Do not use
bleach, do not iron, do not machine wash or tumble dry.
To put the cover back on, start with the top of the shell (39), then the sides
WARNING
• This car seat is a 'Universal' child restraint system. It has been approved in accordance with regulation No.44/04
and is suitable for general use in vehicles and is compatible with the majority (some exceptions) vehicle seats.
• It is more likely that the seat is perfectly compatible if the vehicle manufacturer states that its vehicles are suit-
able for 'Universal' child restraint systems.
• This restraint system is classified as 'Universal' in accordance with the strictest approval criteria, whereas earlier
models do not correspond to these new provisions.
• It can only be adapted to vehicles with 3-point safety belts that are either fixed or have a roller mechanism and
that have been approved to UN/ECE No.16 or other equivalent standards.
• If in doubt, please contact the manufacturer or retailer of the restraint system.
(40) and finally the lower part (41).
User Guide - GB
GB
15