Quick Start - Intel Express 550T Guia De Inicio Rapido

Quick Start

Install the Express
1
550T Switch
Place the switch in a rack or on a shelf or
table, plug the cord in, and turn the power
on.
Connect devices
2
to the Switch
When connecting network devices to the
switch, make sure you use the right type of
cable (straight-through or crossover). See
the diagram to the right.
3
Check port LEDs
• Verify that the Power LED is green.
• The Port LEDs reflect the state of each port:
Green
Off
Blinking randomly
Solid
Blinking randomly
Off
Solid
Orange Meaning
Off Port enabled, no link.
Off Port enabled, Rx/Tx traffic, link pulse active.
Off Port enabled, link pulse active.
Blinking randomly Collision detected. Port enabled, link pulse active.
Solid Port disabled by hardware failure or management.
Solid Port disabled by a fault, or no hardware connected.
Slot A
1 2 3 4
Rubber feet for shelf or table placement.
Brackets and screws for standard
19-inch equipment rack placement.
switch
switch
switch
Slot B
LEDs Green Orange
Intel Express
Off 10 Mbps Half duplex
Solid 100 Mbps Full duplex
550T Routing
Switch
Port Status
Power
Status
Orange
LEDs Green
Temperature
Solid Link Disabled
Reset
Blink Activity Collision RPS
5 6 7 8 Console
9600-8-N-1
PC or
server
printer
switch
or hub
1661
1