Quick Starts; English - Intel 410T Guía Rápida

Quick Start
1
Install the Switch
• Remove the switch and parts from the box.
• Attach the enclosed brackets if you plan
to mount the switch in a rack.
• Install the Intel
Switch in a rack or on a shelf.
• Plug in the power cord.
Connect
2
the Devices
• All ports automatically detect the speed
and duplex-mode of any connected
device.
• Connect PCs and print servers to the
switch with straight-through cables.
• Use a crossover cable to connect a switch
to another switch or hub.
• Use a straight-through cable to connect to
another switch or hub when port 1 is set
to MDI.
• Use only CAT 5 UTP cable to connect
100Mbps devices. To connect 10Mbps
devices, use CAT 3, 4, or 5 UTP cable.
Check the
3
Connections
• Check the port LEDs to confirm the link
status.
• A solid green LED (on the left) indicates
a valid link.
2
®
Express 410T Standalone
Inte l ®
Exp ress 410
T Stan dalo ne
Swi tch
MDI/
1
MDI- X
2
3
4
5
6
7
8
9
10
11
12
13
14
15 Left
16
Link = Solid
Activ ity Green
= Blink ing
Collis ion Green
= Blink ing
Orang e
Righ t
10Mb ps
= Solid
100M bps Orang e
= Off
Shelf: Peel off the protective
backing and attach the rubber
feet to the switch.
From
straight-through
Switch
Switch
crossover
Switch
straight-through
when port 1 set to MDI
Switch
Left (Green/Orange)
Solid Green = Link
Blinking Green = Activity
Blinking Orange = Collision
5
Rack: Use the three small
screws to attach the
brackets to the switch.
Statu s
To
PC/Server
Print Server
10/100
Hub or Switch
10/100
Hub or Switch
Right (Orange)
Off = 100Mbps
Solid = 10Mbps
6 7 8