Tabla de contenido
Publicidad
The bench where the unit is to be installed must measure at least: L 1000 mm, W 600 mm,
H 550 mm and must be able to bear 150 Kg. For safety reasons, the bench must be placed
against a wall while still leaving access to the rear of the machine. Four holes must be
drilled in the bench (see diagram).
20 mm
SLINGING
Before slinging the machine,
take care to remove the wooden
spacers located on either side of
the base. See below for the most
suitable locations for placing the
sling under the machine
114135-Manual-D-EN.indd 3
PREPARING THE INSTALLATION LOCATION
690 (790) +/- 0,4 mm
750 (850) mm
© FAR GROUP EUROPE
DEGREASING
Degreasing is carried out using a
cloth dampened with white spi-
rit. Beware of the vapours that
can be toxic and be sure to pro-
perly ventilate the room
21/03/12 10:44:13
Publicidad
Tabla de contenido
