ICY BOX IB-122CL-U3 Manual De Instrucciones página 5

http://www.icybox.de http://www.icybox.de
4.3 HDD Initialization
by the system.
4.4 2bay docking function
The IB-122CL-U3 allows you to run 2 different HDDs regardles their brands, models or capacities via
one USB connection. Just connect the IB-122CL-U3 to the computer and the HDDs will be detected as
independent drives. Thanks the hot-plug supporting you can exchange the HDDs by running system.
4.5 HDD cloning-function
- Before the cloning process, please remove the USB cable from the device.
- Insert the source drive into slot 1 (source) and the target drive to slot 2 (target).
- Press Power button to power on the device.
- Press and hold the CLONE button for 5 seconds to change to clone mode.
- The first LED of progress indicator (25%) will start to blink. The cloning is in process.
- When the status indicator reaches 100% and stops blinking, your cloning process is completed.
4.6 Advices to the cloning-function
The clone function creates an identical copy of your hard drive – no need to connect to any
computer. You can copy a bootable system disk without additional software or professional
skills.
- Since the cloning process copies every single byte of the source HDD the process may take
several hours depending on the HDD capacity.
- After the cloning process is completed, in some cases the computer may not be able to identify
both drives since they are assigned to the same drive letter. To separate the drives, you must assign
one drive to a new drive letter under "disk management" (Windows).
- If only one drive is plugged into 1 (source), there will be no action when you press the
CLONE button.
- The target HDD (2) must be of the same size or bigger than the source HDD (1).
- If the targets drive (HDD2) is smaller than the source drive (HDD1), after pressing the CLONE button,
the power and remove the HDDs
- You may create a new volume with the remaining space on the target HDD after cloning.
IB-122CL-U3
5 5