Insignia NS-C6500 Manual De Instrucciones página 2

8 Pull the wires through the hole in the ceiling. Strip off the
end of the outer wire jacket, then strip about ½ inch of the
insulation from the ends of the wires.
9 Connect the positive wire on your audio equipment to the red
terminal on the speaker, then connect the negative wire on
your audio equipment to the black terminal on the speaker.
Warning: Make sure that your audio equipment is
turned off before you connect the speaker wires.
10 Remove the speaker grill by pushing one of the Roto-Lock™
screws towards the front of the speaker, then insert the
speaker into the hole in the ceiling.
11 Tighten the screws evenly until the speaker is fl at against the
ceiling.
Caution: If you use a drill to tighten the screws, make sure that you
set the drill to its lowest torque speed. Do not overtighten screws.
12 Reinstall the speaker grill.
Painting the speakers and grills
The speakers have a weather resistant, ABS fi nish that you can paint.
To paint the speakers and grills:
1 Remove the grills from the speakers.
2 Make sure that the interior of the speaker is covered so no
paint will get inside.
3 Insert one of the supplied paint plugs into the speaker to
protect the speaker.
4 Carefully paint the exposed part of the speaker. Remove the
plug when you have fi nished painting.
5 Spray the grill with thin paint (5 parts thinning agent to 1 part
paint). Make sure that you do not plug the screw holes on
the grill with paint. Too much paint may adversely aff ect the
speaker sound.
Specifi cations
Woofer 6 1/2" Gold aluminum cone with a rubber
surrounding
Tweeter ¾" pivoting gold aluminum dome
Frequency 50 Hz to 20 kHz ± 3dB
response
Effi ciency 90 dB 1w 1m
Power 5 watts minimum to 100 watts maximum
2
Impedance 8 ohms nominal
Grill metal 8.98" (228 mm) diameter × 3.70" (94 mm)
dimensions depth
Cut-out dimension 7.68" (195 mm) diameter
Weight 6.9 lbs (3.12 kg) per pair
Outils requis
Crayon
Scie à guichet ou pour cloison sèche
Tournevis cruciforme
Petit niveau
Câble de suspension ou cintre
Outil à dénuder
Gants
Lunettes étanches
Perceuse
Mèche plate de 1 po (si des poutres doivent être percées)
Mèche de ¼ à ½ po (pour percer des trous d' e ssai)
Contenu de l'emballage
2 haut-parleurs Insignia
2 cache-peinture
2 grilles
1 gabarit
Installation des haut-parleurs au plafond
Pour un son stéréo
Installez les haut-parleurs avec un écartement de 6 à 10 pieds (1,8 à
3 m). Chaque haut-parleur doit être à la même distance de la zone
d' é coute. Pour toutes instructions détaillées sur l'installation, voir «
Instructions sur l'installation au plafond ».
Pour un son de cinéma maison
Installez les haut-parleurs avec un écartement de 6 à 10 pieds (1,8 à
3 m) et en arrière de 3 à 6 pieds (0,9 à 1,8 m) par rapport à la zone
d' é coute. Pour toutes instructions détaillées sur l'installation, voire «
Instructions sur l'installation au plafond ».