Packaging; Starting, Operation - SICK PBT Manual De Instrucciones

Operating Instructions

6. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure transmitters
„
Ordered accessories
„
Inspect the pressure transmitter for possible damage during transportation. Should there
„
be any obvious damage, inform the transport company and SICK without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing
„
installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be
„
damaged.

7. Starting, operation

Required tools: wrench (flats 27), screw driver
Diaphragm test for your safety
It is necessary that before starting the pressure transmitter you test the instrument visually, as the
diaphragm is a safety-relevant component.
Pay attention to any liquid leaking out, for this points to a diaphragm damage.
„
Use the pressure transmitter only if the diaphragm is undamaged.
„
Use the pressure transmitter only if it is in a faultless condition as far as the
„
Warning
safety-relevant features are concerned.
20
6. Packaging / 7. Starting, operation
© SICK AG • Germany • All rights reserved
PBT
GB
8013153/V620/2012/03/12