Communication Modules; English; Installation Instructions - Rockwell Automation 2711P-RN Serie Instrucciones De Instalación

Communication Modules

for PanelView Plus 400 and 600 Terminals
Catalog Number 2711P-RNxxx

English

You can attach a Communication Module to the base configured unit of a
PanelView Plus 400/600 terminal with a network interface. These modules are
available as separate catalog numbers for field installation. The installation is the
same for all modules regardless of the communication protocol.
If you connect or disconnect any communication cable with
ATTENTION
power applied to this module or any device on the network, an
electrical arc can occur. This could cause an explosion in
!
hazardous location installations. Be sure that power is removed or
the area is nonhazardous before proceeding.
To install a communication module:
1. Disconnect power from the terminal.
2. If Display Module is removed from panel, set the module, display side
down, on a clean, flat, stable surface to prevent scratches.
3. Remove the label covering the connectors on the base unit of the terminal.
REMOVE LABEL TO INSTALL
COMMUNICATION MODULE

Installation Instructions

Publication 2711P-IN017A-MU-P