Team International TEAM M 25 Manual De Instrucciones página 10

Fax +32 2 359 95 50
(*) Competent qualified electrician: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
WARNING
IN ORDER TO AVOID ACCIDENTS, USE ONLY ONE ACCESSORY AT THE TIME, AS EXPLAINED ON
PAGE 5.
USE OF THE BEATERS AND DOUGH HOOKS
With those accessories you can beat, knead and mix. It is recommended to make round
movements or movements in form of an 8.
•
Make sure the speed switch is in "0" position and the appliance is unplugged from the
power supply.
•
Insert the accessories in the openings at the bottom of the appliance and if necessary,
turn them lightly until you hear a light click.
•
Check their locking by pulling on them lightly.
•
The beaters can be mounted equally in both openings, but for the dough hooks, you have
to respect the sense indicated in page 4 (the hook fitted with a disk has to be placed in
the largest of the two openings of the appliance).
•
Press the ejection button to remove the accessories.
USE OF THE STICK ATTACHMENT
With this accessory you can mix food as for example vegetables to prepare soups but also to
mix liquids. It only has to be used in a vertical position with blades facing downwards.
•
Make sure the speed switch is in "0" position and the appliance is unplugged from the
power supply.
•
Do not forget to remove the other accessories from the appliance.
•
Slide the protection valve on the backside of the appliance to open it. Then you will see
the opening for the stick attachment.
•
Insert the stick attachment in the opening in a way that the triangles situated on the foot
are in front of the triangles situated on both sides of the opening and screw the stick
anticlockwise (as mentioned by the "LOCK" position). Using gentle hand pressure only
ensures that the shaft is fully tightened on to the motor unit.
•
To disassemble the stick attachment, switch off the appliance, unscrew the stick
attachment clockwise and close the protection valve.
•
Caution, the blades of the stick attachment are very sharp, pay attention not to get cut
when cleaning them.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
10
Assembly page 10/28
TEAM M 25 - 080519