Short Cord Instructions; Using The Oven - EFBE-SCHOTT KK 800 Manual De Instrucciones

Fax +32 2 359 95 50
Immediately unplug the appliance if a crack appears and make sure it is controlled by a
qualified competent electrician.
Your appliance must never be switched on through an external timer or any kind of
separate remote control system.
Competent qualified service: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this service.

SHORT CORD INSTRUCTIONS

• A short power supply cord is provided to reduce the risk resulting from becoming
entangled in, or tripping over a longer cord. Extension cords may be used if care is
exercised in their use. Please pay attention to the following:
•
The diameter of the extension cord must correspond to the one of the power cord of the
appliance, in other words, it must be suitable for at least 16 ampere. Extension cords for a
lower amperage could overheat.
• The longer cord should be arranged so that it will not drape over the counter top or table,
top where it can be pulled on by children or tripped over.
BEFORE USE
•
Unpack the appliance and accessories, then wash and wipe these accessories.
•
It is normal if some smoke or smell emanates from the appliance when using it for the first
time. Therefore, we advise you to use your appliance empty once before the first use. If
you want to use the oven, put switch (C) in position
temperature knob (D)to the maximum position (250) for about 10 minutes. This way, the
invisible protective coating of the heating elements will burned. If you want to use the
cooking plates, preheat them during 10 minutes by turning their temperature knob to the
maximum position.
Just like with a traditional cooker, the functions of this appliance can be used individually (thus
oven only or cooking plates only) but you can also use both functions simultaneously.

USING THE OVEN

Operation
• When using for the first time, clean the surface of the tray with a damp cloth and wipe dry.
Then grease the tray with butter, margarine or cooking oil.
• Plug the unit into the power supply socket.
•
To turn on the oven, turn the function selector switch (C) of the control panel in the
position (low heat),
page 2). The indicator lamp in the switch will light up.
•
After you have set the switch to the desired position, regulate the temperature of the
furnace by means of the thermostat (D) - (see picture on page 2).
• When the food is ready, put the temperature knob and the switches in "0" position, the
pilot light goes out.
•
Carefully open the glass door, preferably using an oven glove.
•
Be very careful when removing the rack or the tray. These parts become very hot during
use and you might get burned. Use the supplied, separate handle.
• Unplug the appliance after use.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
(top heat) or (top and bottom heat) - (see picture on
9
Assembly page 9/36
and put the turn the
SC KK 800 110114