Team kalorik TKG KS 4 RP Manual De Instrucciones página 9

Fax +32 2 359 95 50
Please read, follow and keep this instruction manual. Before using your vacuum cleaner for the
first time, charge the accumulator during approximately 16 hours. A fully charged accumulator
will give approximately 10 to 12 minutes of vacuum cleaning.
FIXING THE WALL-MOUNTING BRACKET (see picture A)
• Select a point in the vicinity of a wall socket, indoors and not subject to damp.
• Put the bracket against the wall considering that the appliance should be placed with the
handle facing upwards.
• Take a pencil and mark a dot in each hole situated at the back of the bracket.
• Take the bracket off the wall and drill a hole on each dot you just marked.
• Put a plug in the holes and tighten the screws in the holes, letting them more or less 4
millimetres out of the wall.
• Fix the bracket by putting the screws into the widest part of the holes situated at the back
of the bracket and slide the bracket downwards.
CHARGING THE VACUUM CLEANER
The adaptor should only be connected to a 230V, 50Hz power supply.
Important: The charger and its cord cannot be repaired. Should they be damaged, they must
be thrown out. Contact the customer service to replace them.
Put the "jack" plug of the charger in the opening foreseen underneath the wall-mounting
bracket and rotate it until it is firmly attached to the bracket (see picture B).
Insert the vacuum cleaner on the bracket with its handle facing down (a hook at the back of
the appliance allows you to attach it easily to the bracket) (see picture C). Make sure the
"jack" plug enters the appliance in the opening foreseen in the back of the appliance. Insert
the plug of the adapter into a 230V wall socket. The charging indicator will come on,
indicating that the vacuum cleaner is positioned correctly on the bracket and that the
charging process will start. The charging indicator will stay illuminated even if the battery is fully
charged.
You can leave your appliance on the bracket for a long time without any risk of deterioration.
Do not charge the battery if the room temperature falls below 0°C or rises to more than 37°C.
The charger will warm up during use. This is perfectly normal. It will cool down as soon as the
charging process is over.
USE
Once your appliance is charged, remove it from the bracket by holding it by its handle. Switch
it on by sliding the ON/OFF switch forward. Tilt the vacuum cleaner till the nozzle of the dust
collector is placed horizontally compared to the surface that is to be cleaned. When you are
finished, slide the ON/OFF switch backward to switch off the appliance.
Practical hint: your appliance is equipped with a small crevice tool, which also serves as a
base for several attachments. You can also use this crevice tool to avoid scratching the nozzle
of the dust compartment.
To clean surfaces that are difficult to reach, use one of the crevice tools supplied. Caution: the
large crevice tool cannot be attached directly to the appliance, but must first be fitted to the
small crevice tool, which can then be attached to the appliance. To clean flat damp surfaces,
use the squeegee directly mounted on the dust compartment. When vacuuming liquids, make
sure the level of the liquid never exceeds the max level of the dust compartment.
After having vacuumed liquids or humid particles, clean the dust collector to avoid smells.
Then dry the filter thoroughly if necessary (see "Cleaning and maintenance" section).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
9
Assembly page 9/28
TKG KS 4 RP - 090708