Installation And Connection - OAS biOrb HALO Serie Instrucciones De Uso

- EN -

INSTALLATION AND CONNECTION

Setting up the aquarium
How to proceed:
• Carefully unpack the acrylic aquarium.
• Do not expose to direct sunlight.
• Only set up in closed rooms.
• Do not move the aquarium when it is filled.
• Do not place on or near electrical devices.
• Do not place on or near heat sources.
• Operation under observance of the technical data.
Fitting the filter unit
How to proceed:
• Remove the packaging from the filter medium.
 B
1. Open the cover.
2. Remove the insert if necessary.
3. Release the air column from the filter housing by a
quarter turn counterclockwise (bayonet closure)
and lift out.
4. Place the air column onto the filter cartridge and
fasten the air column by a quarter turn counter-
clockwise.
5. Insert the air column into the aquarium and fasten
it to the filter housing by a quarter turn clockwise.
Using the ceramic substrate
N O T E
Remove the packaging from the filter medium. Thor-
oughly rinse the ceramic substrate with warm tap wa-
ter before using for the first time to remove any soil-
ing.
N O T E
• Do not use aquarium gravel as it could clog the filter
cartridge.
• Only use the ceramic substrate provided.
• Do not tip the ceramic substrate into the aquarium
from a height as it could scratch the acrylic.
• Only use ceramic substrate particles that are at least
pea-sized. Remove and dispose of any particles that
are smaller.
How to proceed:
 C
• Place the supplied ceramic substrate carefully into
the aquarium and arrange it around the filter hous-
ing.
20
Installing and connecting the aerator pump
N O T E
When installing the unit, ensure that it
• is located outside the aquarium
• is not placed on or over the aquarium
• cannot fall into the water or move out of position.
Damage resulting from incorrect installation is not ba-
sis for a claim within the framework of the guarantee
or warranty.
How to proceed:
 D
1. Connect the air hose leading out of the aquarium to
the air connection of the aerator pump and fit the
aerator pump above the subsequent level of the
aquarium water. This prevents water from leaking
or damage to the pump in case the integrated non-
return valve should fail.
2. Connect the connection cable to the separate
socket of the plug-in transformer but do not yet
connect the plug-in transformer to the mains
socket. First complete the start-up preparations.
Connecting the lighting unit
N O T E
Never immerse the lighting units in water or other liq-
uids.
biOrb HALO 30 LED
How to proceed:
 E
1. Insert the cover insert into the cover ring.
2. Ensure that the four holding tabs are in the correct
position, otherwise the cover may not fit properly.
3. Connect the connection cable to the separate
socket of the plug-in transformer but do not yet
connect the plug-in transformer to the mains
socket. First complete the start-up preparations.
biOrb HALO Moonlight LED /
biOrb HALO 15 MCR LED
How to proceed:
 F
1. Connect the connection cable for the lighting unit
(plug) to the socket in the cover ring.
2. Connect the connection cable to the separate
socket of the plug-in transformer but do not yet
connect the plug-in transformer to the mains
socket. First complete the start-up preparations.
COMMISSIONING/START-UP
Filling with and preparing the water
It is necessary to prepare the aquarium water by add-
ing "Water Conditioner" and "Biological Booster".
biOrb HALO