Step 4. Mounting The Drive In The Bay; Step 5. Attaching The Cables To The Drive - IBM OPTIONS 22P6952 Guia Del Usuario

Tabla de contenido

Publicidad

Step 4. Mounting the drive in the bay

Attention: Be sure to use the mounting screws in the option package when
you are driving screws directly into the drive. Using screws that are too long
might damage the drive.
You can mount the DVD-ROM drive horizontally or vertically in the computer.
If you mount the drive vertically, you must secure any discs that you place
into the drive before the drive tray is closed, or the DVD-ROM drive will not
be able to read the disc properly.
1. Slide the drive into the bay. Your computer might have specific required
procedures for installing storage devices. For more information on storage
devices, refer to the documentation that comes with your computer.
2. Align the drive-bay screw holes with the threaded holes in the drive
housing or mounting bracket.
3. Thread the screws in loosely to check their position. Two screws are usually
used on each side. Verify that the alignment is correct; then tighten the
screws to secure the drive. Do not overtighten.

Step 5. Attaching the cables to the drive

The following diagram shows where to connect the cables to the drive.
1-6
IBM 16X Max RAM-Read DVD-ROM Drive: User's Guide

Publicidad

Tabla de contenido
loading

Tabla de contenido