Accessory Power ENHANCE ATTACK Manual De Instrucciones página 15

Product specifications

Spécifications du produit

Especificaciones del producto

Produktspezifikationen

Specifiche del prodotto

产品规格

Speaker power: (10W x 2) 20W RMS ; 40W peak

Driver: 50mm x 2

Impedance: 4 Ohms

Frequency response: 75Hz-18kHz

S/N Ratio: >65 dB

Audio input: 3.5mm AUX (2)

Power input: 12V⎓2A

USB / Audio cable length: 60 inches

Dimensions: 15.75 x 4.25 x 3.25 inches

Weight: 2.51 pounds

FCC Compliance Notice

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Puissance du haut-parleur: (10W x 2) 20W RMS; 40W max

Pilote: 50 mm x 2

Impédance: 4 Ohms

Réponse en fréquence: 75Hz-18kHz

Rapport Signal/Bruit:> 65 dB

Entrée audio: 3.5 mm AUX (2)

Puissance d' e ntrée: 12V⎓2A

Longueur du câble USB/audio: 1,52 m

Dimensions: 40 x 10,79 x 8,25 cm

Poids: 1,13 kg