Packing List - Inateck FE2013 Manual De Instrucciones

Hot plug，plug&play
Switch
Licenses
Measurements
Supported OS

Packing list

Inateck FE2013 × 1
USB 3.0 data cable × 1
Instruction manual × 1
Sponge Pad × 1
Note
a. Make sure data access and transfer are stopped when
remove the hard drive enclosure from computer, otherwise
data loss might happen.
b. To ensure normal work, please make sure the rated power of
hard drive complies with the output power of the USB port
on the hard drive enclosure.
c. Hard drive will automatically start sleep mode if idle state
lasts 30 minutes, when LED comes into breathing light state.
Data access to the drive will restore operational mode.
d. Normally a drive can be used with the enclosure directly,
which will be shown as "New Disk" on computer. If
"New Disk" does not appear, there might be something
wrong with your disk partition or format. In that case,
please use the partition and formatting program that
come with system to reformat the hard drive. (Right click
"Computer">Management>Disk Management）
e. Due to different thickness of 2.5"hard drive, a sponge pad
was provided. Users are suggested to paste the pad on the
inner side of the enclosure shell, to avoid hard drive sliding
if it is too thin.
supported
Yes
CE，FCC
132.6x81.5x15.6mm
Windows XP/7/8/10；Mac9.0 or above，Linux
3