Inateck FE2004C Manual De Instrucciones página 4

3..Slide the top panel back into place.
4. With the enclosure fully assembled, connect the USB
3.0 cable from the enclosure to a USB port on the host
computer system using the included cable.
Note:
a. To remove the hard drive, make sure it is currently
not being accessed by the computer then unmount
or uninstall the disk drive from the operating system.
Never remove the enclosure while the hard drive is in
use. Doing so may corrupt the data on the hard drive or
damage the hard drive, enclosure, or computer.
b.Your hard drive must be USB-powered as no external
power adapter is included.
c. Please attach the included foam pad to the back side of
the top panel to stabilize and protect your ultra-thin hard
drive.
3