Assigning Channels - EASYHOME GT-FSI-07-US Manual Del Usuario

USA
Preparation
− Only use the remote controlled wall sockets in indoor
areas. Do not use it in wet rooms or in the rain.
− Only connect the remote controlled wall sockets to an
easily accessible socket so that you can quickly disconnect
it from the grid in case of a failure.
− The remote controlled wall sockets may heat up during
operation. Make sure that the remote controlled wall
sockets are not covered by curtains or other objects in the
process; this will ensure that they are properly cooled.
− Never expose the remote controlled wall sockets to high
temperatures (heaters etc.) or to the effects of the weather
(rain etc.).

Assigning channels

1. Connect one of the remote controlled wall sockets to a properly installed
socket.
13
The indicator light
(learning mode).
2. Push any button on the remote control.
The indicator light on the remote control will flash/blink.
3. To assign a channel to the remote controlled wall socket control, push the
ON button 8 / 9 /
The indicator light of the remote controlled wall socket will illuminate
continuously when the remote controlled wall socket is connected with the en the remote co en the remote co
remote control. .
T TIP: T IP IP: :
The learning mode is restricted to 30 seconds after you have he lear he learn
inserted the remote controlled wall socket. If you are unable to rte rte
assign a channel during learning mode, repeat steps 1 – 3.
4. Push the OFF button
the remote controlled wall socket off.
5. If you would like to assign multiple channels to a remote controlled wall
socket,
− first assign a channel to it by following steps 1 – 3.
− Then pull the remote controlled wall socket out of the permanently
installed socket and follow the steps 1 – 2 again.
− In step 3, assign another channel to it.
The remote controlled wall socket can now be controlled via both channels.
12
service@801service.net
of the remote controlled socket will flash for 30 seconds trolled socket w trolled socket w
control. rol.
ote control will control wil
remote controll mote control
10 / / 11 1 for the desired channel during learning mode. for the d for the de
f the remote con e remote c
2 / 3 / 4 / 5 for the respective channel to switch
Remote controlled wall sockets
s of th f th
ockets to a prop kets to a prop
AFTER SALES SUPPORT
USA
1-866-558-8096