Precor UBK 665 Referencia Rápida página 10

Clean the running belt and deck (treadmill
only)
Before you begin the cleaning procedure, check that the safety stop
key works correctly.
CAUTION
DO NOT stand or allow others to stand on the treadmill
running belt during this procedure.
To make sure the safety stop key works:
1. Stand to one side of the treadmill.
2. Make sure that the stop key lanyard is hanging straight down
and is not wrapped around the handle bars.
3. Press QuickStart and wait for the running belt to begin moving.
4. Press the safety stop key.
5. The running belt should stop immediately. When it stops, reset
the safety stop key.
CAUTION
If the running belt does not stop, turn off the treadmill
power using the On/Off switch at the front of the
treadmill and unplug the power cord. The treadmill must
remain out of service until the stop switch is repaired.
Place an "out of order" sign on the treadmill and contact
Precor Customer Support.
Turn the treadmill power switch to Off. The On/Off switch is located
at the front of the treadmill.
To clean the treadmill belt and deck:
1. Make sure the treadmill is turned off.
2. Take a clean, dry cotton towel that is at least 36 in. (2 m) long
and fold it in half lengthwise.
3. Lift the running belt up and push the towel under the belt. Make
sure a few inches of towel extend over the deck trim on each
side.
4. Push the towel forward to the front of the machine so it is
located beneath the safety stop key.
5. Turn the power switch to On.
6. Step onto machine by standing on the side rails and attach the
stop key lanyard to your clothes.
IMPORTANT
DO NOT stand on the running belt at any time.
7. Stand firmly on both ends of the towel keeping your feet off of
the treadmill running belt (Figure 2). Brace yourself using the
handlebars or side hand rails.
Figure 2
8. Press QuickStart.
IMPORTANT
You have three seconds before the treadmill belt begins to
move. Hold the handlebars or side hand rails to help
maintain balance.
11