Moving The Equipment - Precor UBK 665 Referencia Rápida

Verify that the heart rate display works
To verify that the heart rate display is operational:
1. Begin exercising on the equipment and grasp both touch-
sensitive handlebars. The heart icon flashes while the heart rate
is read. You must maintain contact with both metal plates on
each handlebar to ensure an accurate reading.
2. Within ten seconds, your heart rate number appears in the
HEART RATE display. If a number does not appear, perform the
following checks:
• Verify that the HR cable is properly connected.
• Repeat the test with a different person. In rare instances, it
may not work properly for a few individuals.
• Repeat this test using a chest strap or a wireless pulse
simulator. You'll get better results than if you only grasp the
touch-sensitive handlebars. DO NOT hold onto the handlebars
during the reading or you'll override those results.

Moving the equipment

The equipment is very heavy. If you plan to move it to a new
location, obtain the help of an adult assistant and use proper lifting
techniques. If the equipment includes roller wheels on one end, use
the wheels to reduce the load on yourself and your assistant.
To move the elliptical (EFX):
Precor recommends using a four-wheeled dolly to move the EFX.
To move the AMT:
1. Disconnect, unplug, and remove all external connections
(television, Ethernet, and power).
2. Lift the rear platform molding to remove it.
3. Lift the rear foot supports to tip the AMT forward onto its roller
wheels.
4. Push the AMT into its new location.
5. Lower the rear foot supports to the floor, then reattach the rear
platform molding.
To move the treadmill:
A treadmill in an inclined position is easier to move.
IMPORTANT
The plastic end caps on Precor treadmills are designed
specifically for lifting. Working with your assistant, place a hand
under each side of the end cap. Then, using proper lifting
techniques, lift the rear of the treadmill so that it rolls on its
front wheels.
To put the treadmill into an inclined position for moving:
1. Press GO on the console.
2. Increase the incline to Level 4 or more.
3. While the treadmill is running, turn the main power switch to
OFF.
4. Disconnect the treadmill's power cord.
8