Electrical Information - LawnMaster BV1211 Manual Del Usuario

SYMBOLS
The following signal words and meanings are intended to explain the levels of risk associated with
this product.
WARNING
To avoid serious personal injury, do not attempt to use this product until you read
thoroughly and understand completely the operator's manual. If you do not understand
the warnings and instructions in the operator's manual, do not use this product.
Call customer service for assistance (866)-384-8432.
The operation of any power tool can result in foreign objects being thrown into your
eyes, which can result in severe eye damage. Before beginning power tool operation,
always wear safety goggles or safety glasses with side shields and, when needed, a
full face shield. We recommend Wide Vision Safety Mask for use over eyeglasses or
standard safety glasses with side shields. Always use eye protection which is marked
to comply with ANSI Z87.1.

ELECTRICAL INFORMATION

DOUBLE INSULATION
Double insulation is a concept in safety in electric power tools, which eliminates the need for the
usual three-pronged grounded power cord. All exposed metal parts are isolated from the internal
metal motor components with protecting insulation. Double insulated tools do not need to be grounded.
WARNING:
The double insulated system is intended to protect the user from shock resulting from a break in
the tool's internal insulation. Observe all normal safety precautions to avoid electrical shock.
NOTE: Servicing of a product with double insulation requires extreme care and knowledge
of the system and should be performed only by a qualified service technician. For service,
we suggest you return the tool to your nearest authorized service center for repair. Always
demand that original factory replacement parts be used when servicing.
ELECTRICAL CONNECTION
This product has a precision-built electric motor. It should be connected to a power supply that
is 120 volts, AC only (normal household current), 60 Hz. Do not operate this product on direct
current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat. If
your product does not operate when plugged into an outlet, double-check the power supply.
7