Instruction Sheet - Vimar Eikon 20140 Hoja De Instalación

Ocultar thumbs

página de 6

/ 6
Marcadores

Idiomas disponibles

Eikon

Plana

20140

14140

20141

14141

20140 - 14140

230 V~ dimmer for incandescent lamps 40-700 W at 50/60 Hz, ferromagnetic trans-

formers 40-700 VA, control and regulation with built-in button or from several positions

with N.O. buttons, MASTER function for 20141 and 14141, MOSFET+TRIAC technol-

ogy, identification in the dark, protection fuse, grey - 2 modules

20141 - 14141

230 V~ SLAVE dimmer for incandescent lamps 40-700 W at 50/60 Hz, ferromagnetic

transformers 40-700 VA, control from 20140 and 14141, MOSFET+TRIAC technol-

ogy, protection fuse, grey - 2 modules

Characteristics

• SLAVE dimmers need MASTER dimmers to function.

• Lighting, adjusting and turning off with incorporated buttons or normal N.O. buttons

without pilot light.

• Lighting level is saved when turned off (unless there is a blackout).

• Soft start: ensures gradual lighting from zero to maximum or preset lighting levels.

This way the life of a lamp is increased by reducing stress on the filament and

prevents light flash.

• Soft end: ensures a gradual passage from light to dark.

• Fuse with high breaking capacity type F5AH (07050.HF.5) incorporated.

• Overheating protection with flashing blowout detector.

• MASTER-SLAVE function: paying attention not to exceed maximum power control-

lable by each dimmer, a MASTER device can have up to 4 SLAVE devices added.

• It should be used in dry, dust-free places at a temperature between -5 °C and

+45 °C.

Connections

• Control and dimming with incorporated button or several points with NO buttons in

parallel (figure A). Do not use NO buttons with pilot light.

• Control and adjustment with incorporated button + control and adjustment of fur-

ther loads using the SLAVE support module (max 4) (figure B).

Note.

• Loads controlled by each device are not parallel in the MASTER-SLAVE function.

• Maximum length of cables connecting MASTER dimmer and SLAVE dimmer: 100

metres.

Controllable loads

• Incandescent and halogen lamps: 40-700 W 230 V~ 50/60 Hz.

• Ferromagnetic transformers for low-voltage halogen lamps: 40-700 VA 230 V~

50/60 Hz.

WARNING: The above power data are guaranteed at an ambient temperature of

25°C; for each increase of 10°C in the ambient temperature, the power value must

be reduced by 10%.

20140

14140

Viale Vicenza, 14 - I 36063 Marostica VI

Tel. +39.0424.488.600 - Fax: (Export) +39.0424.488.709

www.vimar.eu

Constructor further information

• Not suitable to control motors (e.g. ventialtors and exhaust fans).

• For installation with 2 dimmers in the same mounting box, the loads controllable

by each dimmer should be reduced so that theri total does not exceed the values

indicated above.

Operating

• Turn on and off by pressing the button quickly and make adjustments by keeping it

pressed. Stop and restart to change direction.

When maximum or minimum load is reached, dimming stops and can be inverted

by pressing the dimmer again.

• If the pilot light does not turn on check the fuse and if necessary replace it with the

same model.

• If the pilot light flashes after turning on, installation has not been carried out correctly

and the overheating protection has been activated. Have the system checked by

an expert.

Installation regulations

• The installation should be carried out in compliance with current electrical installa-

tion regulations in the country where installed.

• The rated power level should never be exceeded.

• Overloading, power surges and short-circuits may permanently damage dim-

mers. Before installation check the circuit carefully and eliminate any of the above

causes.

• Do not connect several dimmers in series between each other.

• The dimmer does not have a mechanical circuit breaker in the main circuit and so is

not galvanically separated. The circuit load should be considered always under

voltage.

20140

14140

In order to function correctly the length of each connection between the MASTER dimmer and

SLAVE dimmer or NO buttons should not exceed 100 m.

Characteristics of

Controllable

controllable

loads

transformer

–

20141

14141

ENGLISH