Package Contents; Description (Fi G. A); Electrical Safety - DeWalt DC800 Traducido De Las Instrucciones Originales

E N G L I S H
Charge only between 4 °C and 40 °C
Have defective cords replaced immediately
Charger problem
Battery problem
Discard the battery pack with due care for
the environment
Do not incinerate the battery pack
Charge D WALT battery packs only with
E
designated D WALT chargers. Charging
E
battery packs other than the designated
D WALT batteries with a D
E
may make them burst or lead to other
dangerous situations.

Package Contents

The package contains:
1 Cordless impact wrench
1 Battery pack (D1, M1))
2 Battery packs (D2, M2)
1 Charger
1 Kitbox
1 Instruction manual
NOTE: Battery packs and chargers are not included
with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fi g. A)
WARNING: Never modify the power tool
or any part of it. Damage or personal
injury could result.
1 On/off switch
2 Tool holder
3 Pistol grip
4 Date code
5 Battery pack
6 Release button
30
7 Charger
8 Charging indicators (red)
INTENDED USE
These DC800 impact wrenches are designed for
professional screwdriving and nutsetting applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty impact wrenches are professional
power tools.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or infirm
persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
WALT charger
E
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the
plug.
• Connect the blue lead to the neutral terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore no
earth wire is required.
WARNING: No connection is to be made
to the earth terminal.