installation instructions
WEIGHT CAPACITY 300 LBS (136 KG)
1. Turn shower chair upside down on flat surface.
2. Insert legs into shower chair. Be sure snap buttons
pop out through legs completely (Figure 1).
3. Turn over shower chair with legs attached so all four
legs are on the floor.
4. Slide elbow tubing into back receptacle under the seat
(Figure 2). Be sure snap buttons pop out completely.
Repeat for second elbow.
5. Attach back support into elbows (Figure 3). Be sure
snap buttons pop out completely.
adjusting leg extensions
1. Select one (1) of the eight (5) adjustment holes located
on the lower leg frame.
2. Depress the snap button and slide the adjustable leg
up or down to the desired height.
3. Ensure that the snap buttons fully protrude through the
same respective adjustment hole of each leg extension.
4. Repeat STEPS 2-3 for the other legs.
5. Make sure all four (4) legs are adjusted to the same
height so that the shower chair sits level.
figure 1
Rev.5.02.25.14
figure 2
figure 3
lifetime limited
warranty
Your Drive branded product is warrantied to be
free of defects in materials and workmanship for
the lifetime of the product for the original consumer
purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non-durable
components, such as rubber accessories, casters,
and grips, which are subject to normal wear and
need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2014 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China