Product Specification - LUND 68050 Manual Del Usuario

GB

PRODUCT SPECIFICATION

The electric oven is a portable device intended for heating, cooking and preparation of dishes requiring thermal processing.
Temperature control, forced air circulation, rotisserie and the possibility of choosing which heater should operate allows for a
wide adjustment of the product to your needs. The product is designed for domestic use only and may not be used in commercial
applications. Correct, reliable and safe operation of the product depends on proper use, that is why:
Reading and keeping the entire manual before the fi rst use of the product is necessary.
The supplier shall not be liable for any damage or injury resulting from improper use of the product, failure to comply with the safety
regulations and recommendations of this manual. Using the product in a way other than intended will also result in the loss of
user's rights to guarantee, as well as under warranty.
ACCESSORIES
The oven is supplied complete and does not require assembly. However, before using the product, remove all packaging and
transport protection elements. Preparatory activities described later in this manual are also required.
GENERAL INSTRUCTIONS FOR USE
The product is intended only for heating, cooking and preparation of dishes requiring thermal processing.
It is forbidden to use the device in any other way, e.g. for heating rooms or for boiling water.
It is forbidden to repair, disassemble or modify the product on your own. All repairs to the product must be carried out by an
authorised service centre.
The product must be kept under supervision at all times during operation.
WARNING! The product heats up to a high temperature during operation. Do not touch the sides of the product while it is in op-
eration, as this can result in serious burns. The temperature of accessible parts may be higher when the appliance is operating.
The product is not intended for use by children under at least 8 years of age, and by persons with reduced physical and mental
capabilities, and persons with lack of experience and knowledge concerning the appliance. Unless they will be supervised or
instructed to use the product safely, so that they understand the hazards involved. Children should not play with the product.
Unattended children should not be allowed to perform the cleaning and maintenance of the appliance.
Keep the appliance and its power cord away from children under 8 years of age.
Recommendations concerning transport and installation of the product
The product may only be placed on a hard, fl at, even and non-fl ammable surface. The surface should be able to withstand the
weight of the appliance itself and of the food it contains.
A gap of at least 10 cm must be provided around the sides and back of the product and at least 30 cm above it. This will allow for
the proper ventilation of the product. Do not place materials above the product which are not resistant to high temperatures. Do
not place near edges of, e.g., a table.
Do not place any electrical equipment, including sockets, above the product. Steam is released during operation which may cause
a short circuit in the electrical system and lead to electric shock.
It is forbidden to drill any holes in the product, as well as making any other modifi cations of the product which are not described
in the manual.
Handle the product only once it has cooled down, grasping the bottom of the housing. Do not move the product by pulling on the
power cord.
The temperature at the place of installation and use of the product must be within the range of +10 C ÷ +38 C, and the relative
O O
humidity must be below 90% without condensation.
Recommendations for connecting the product to the power supply
Be sure to check that the voltage, the frequency and capacity of the mains supply are as indicated on the product nameplate,
before connecting the product to the power supply. The plug must fi t into the socket. It is forbidden to modify the plug in any way.
The product must be connected directly to a single mains socket. The use of extension cords, splitters and double outlets is pro-
hibited. The mains supply circuit shall be equipped with a protective conductor and a protective device of at least 16 A. The circuit
of the mains supply shall be equipped with a residual current fuse of at least 30 mA tripping current.
Avoid contact of the power cord with sharp edges, hot objects or surfaces. The power cord must always be fully extended when
the product is in operation, and its position must be determined in such a way as to not obstruct the operation of the product. The
power cord shall not be placed a manner that would pose a risk of tripping. The socket should be located in a spot that would
enable the plug of the product's power cord to always be unplugged quickly. Always pull the power cord by the plug housing when
unplugging it, never by the cord.
If the power cord or plug is damaged, immediately disconnect it from the mains and contact an authorised service centre of the
manufacturer for replacement. Do not use the product with a damaged power cord or plug. The power cord or plug cannot be
O R I G I N A L I N S T R U C T I O N S
10