Publicidad
453401
1102
Operation (Continued)
3. Connect roller to gun and position at desired angle. Tighten
with wrench.
PRESSURE ADJUSTMENT
1. For units with a single prime/pressure control, turn
the control knob approximately one turn from the prime
position.
IMPORTANT: Very little pressure is required for rolling.
2. Set sprayers with separate pressure control at lowest pressure
which provides a steady flow of paint.
PAINT APPLICATION
1. Trigger gun until paint appears on roller.
2. Roll roller on wall until roller is saturated.
3. Begin painting and trigger often enough to keep rolling
smooth and effortless.
Maintenance
1. Remove the slotted bolt and pull the cover off.
Figure 2
www.chpower.com
11/12/02
3:02 PM
Page 2
Roller
End Caps
2
Cover
Publicidad
