Kalorik USK EXP 4 Manual De Instrucciones página 10

TROUBLESHOOTING
Problem Possible cause/cause
The coffee is The cup and the infusion
not hot head are cold.
enough.
The coffee The filter holder is fitted
drops from properly to the infusion
the side of head; or some powder
infusion on the side of infusion
head. head; or some remaining
coffee on the gasket for
infusion head; or the
gasket is broken.
The pump No water in tank; or the
makes a lot tank is not correctly
noise positioned into the
appliance; or the coffee
powder is not fresh, too
dry.
No water will No water in tank; or the
come out. tank is not correctly
positioned into the
appliance; or the filter
holder is blocked; or the
powder is too fine, not
tamped down enough;
or a scale in machine.
Beverage is The powder is too
running fast. coarse; or the coffee
powder is not enough; or
the coffee powder is not
tamped down enough.
Frothing is Steam pipe is blocked; or
not ideal. the milk is not fresh; or
the milk is not cold; no
water in tank.
Solution
Pre-heat cups, infusion
head and other
attachments.
Check the infusion
head; remove the
powder from infusion
head; wipe the
gasket with a wet
cloth;
You may contact
service center for a
new gasket.
Fill the tank with
water; put the tank in
correct position; use
the fresh coffee
powder.
Fill the tank with
water; put the tank in
correct position; clean
up filter holder and
use coarser powder;
descale the machine
Use finer powder; add
more powder; tamper
the powder tightly.
Clean up steam pipe;
use fresh milk; use the
cold milk; fill the tank
with water.
10
USK EXP 4 - 070830