Wolf Garten LYCOS 40/300 T Instrucciones De Funcionamiento Originales página 24

EN
Tips for use
Beware of injuries to the feet and hand
caused by the cutting element.
Remove the power pack from the device:
- Whenever you leave the device unattended.
- Before removing blockages.
- Before checking cleaning or working on the
device.
- After impacting a foreign body to check the de-
vice for damage.
- For immediate checking if the device starts to
vibrate excessively.
Do not use the device in potentially explosive
gases or dusts. The device can generate
sparks which could ignite dust or vapours.
Never leave the device unattended during
breaks and store it in a secure location.
Hold the device parallel to the lawn when
switching on, otherwise there is a risk of
injury.
When working also maintain a safe distance
relative to the rotating line/cutting blade.
Do not reach into the area of the rotating line
or the blade.
Do not try to catch hold of rotating parts.
Do not injure yourself on the line cutter.
After pulling out new line, always hold the
device in its normal working position before
you switch it on.
Wear suitable safety goggles and ear defend-
ers!
The protective cover must always be fully
attached when you are using the device as
a lawn trimmer. Both trimming lines must be
pulled out for operation and the correct line
must be installed. The trimming line must not
be pulled out beyond the end of the cover.
The protective cover must always be attached
when you are using the device as a brush
cutter with a cutting blade.
Before switching on the device, ensure that
the line spool/blade will not come into contact
with any object.
Adjust the level of the middle handle to match
your height so that you have a good grip of
the device.
Only use the device in daylight or under
Only use this device for its intended purpose.
24
Safety information
hands during operation: one hand on the han-
dle, the other hand on the middle handle.
Always wear the carrying belt during opera-
tion.
When working, alternate your position and
take breaks to prevent tiredness and fatigue.
Adopt a normal posture. Ensure you are
standing securely and that you maintain your
balance at all times. Pay particular attention, if
you are working on a slope. Do not run, rather
walk forwards at a steady pace. This will ensure
that you can maintain better control of the device
if unexpected situations occur.
Take extra care if you are walking backwards.
Risk of tripping!
Remove the power pack when carrying the
device to or from separate working positions.
Never bypass or manipulate safety devices
installed on the device.
Do not allow the line head to impact against
wall edges. If the line head suddenly receives
a heavy blow, be prepared for increased vibra-
tion at the handle. If this does occur, the device
must be checked and, if necessary, repaired by a
Additional instructions for operation using
the cutting blade
Always keep the middle handle with stand-
attachment.
Never cut with the cutting blade at a height of
75 cm or greater above ground level.
Kickback can occur if the rotating blade im-
pacts an object which cannot immediately be
cut through.
device and/or user in any direction resulting
in possible loss of control of the device.
Kickback may occur without warning if the
blade becomes stuck, clamped or blocked.
cult to oversee the material to be cut.
When using the cutting blade, do not cut any-
thing that is thicker than 12.7 mm. Otherwise
severe kickback can occur.
when using the cutting blade.
Do not attempt to touch or stop the blade
when it is turning.
For your safety
-