Generac G0071031 Hoja De Instrucciones página 2

Installing the Breather Heater
(9kW Models)
1. See Figure 3. Wrap the breather heater (A) around the
breather hose, evenly spaced as shown, with the lead
wires at the bottom. Once installed, wrap the breather
heater and hose with silicone tape (provided) to secure
heater.
A
Figure 3. Wrapping the Breather Hose (9 kW)
2. See Figure 4. Route the lead wires beneath and behind
the engine as shown.
D
Figure 4. Routing Heater Wires (9 kW)
3. See Figure 5. Pass the lead wires through the harness
grommet (B) in the engine divider panel. and then through
the customer connection panel grommet (C). Secure all
wires with plastic wire ties at least 0.5 in. (1 cm) away from
fuel hoses.
B
Figure 5. Lead Wires to Customer Connection (9 kW)
4. Proceed to Connecting Lead
Breather Heater Kit
002760
002762
C
002763
Wires.
Installing the Breather Heater
(11–22kW Models)
1. See Figure 6. Remove the airbox cover (A), intake elbow
(B), and air filter (C).
A
C
Figure 6. Removing the Airbox Cover (11–22 kW)
2. See Figure 7. Unscrew and remove the airbox base (D).
Figure 7. Removing the Airbox Base (11–22 kW)
3. See Figure 8. Remove three mounting screws behind the
engine divider panel to disconnect the snorkel (E).
E
Figure 8. Removing the Snorkel (11–22 kW)
(continued on next page)
B
002765
D
002766
003080
2