Completing Installation - Generac G0071031 Hoja De Instrucciones

2013–2015 Units—
See Figure 13. Connect the heater lead wires to the T1
terminal and Neutral stud as shown.
Figure 13. Input Sense Terminal Block
NOTE: Wire with ring terminal connects to Neutral bar stud.

Completing Installation

Engine damage. Verify proper type and quantity of
engine oil prior to starting engine. Failure to do so
could result in engine damage.
1. Check all wire routing to verify wires will not be pinched or
cut. Use tie wraps where necessary.
2. Install customer connection panel cover.
3. Return the utility power supply to the transfer switch:
• In service rated transfer switches, turn the main breaker
ON.
• In non-service-rated switches, turn power feeder breaker
ON.
NOTE: If removed, install the T1, N1 and N2 fuses in the
transfer switch.
4. Install controller fascia (2013–2015 units) or intake side
panel (2016 and newer units), front panel, and 7.5A DC
fuse.
5. Complete the installation wizard programming.
6. Move the main line circuit breaker (generator disconnect)
to ON (closed).
7. Place the generator controller in AUTO and close lid.
Part No. 10000022351 Rev B 09/11/17
©2017 Generac Power Systems, Inc. All rights reserved
Specifications are subject to change without notice.
No reproduction allowed in any form without prior written
consent from Generac Power Systems, Inc.
CAUTION
005566
(000135)
Generac Power Systems, Inc.
S45 W29290 Hwy. 59
Waukesha, WI 53189
1-888-GENERAC (1-888-436-3722)
www.generac.com