Uline simplehuman H-7214 Manual De Instrucciones página 2

TAPE MOUNTING
IMPORTANT! Thoroughly scrub and clean
intended mounting surface with any household
bathroom cleaner. Wipe with provided alcohol
pad. Allow surface to dry fully or adhesive will
not set properly.
1. Peel tape backing from wall plate. (See Figure 5)
Figure 5
Tape Backing
CLEANING
1. Remove pump from wall and clean with warm, soapy water.
2. To clean without removing from wall, fill with water and pump until water is gone.
NOTE: Soaps with exfoliants or moisture beads may clog the pumps.
NOTE: Do not use abrasive or chemical cleaners. Do not put the pumps in the dishwasher.
PAGE 2 OF 6
INSTALLATION CONTINUED
2. Press wall plate firmly at desired location on wall for
3. Snap the accessory clips into the dispenser.
4. Insert hooks into wall plate. Push dispenser down
MAINTENANCE
1-800-295-5510
uline.com
at least 30 seconds to secure the adhesive.
NOTE: Wait a minimum of two hours before
mounting dispensers. For best results, wait
24 hours.
(See Figure 4)
until it locks into place. (See Figure 4)
1021 IH-7214