Safety Device; Machine Description - Comet DSG-10 EX Instrucciones Para El Uso

Risk of explosion — Do not spray flammable
21i
liquids.
08i High pressure hoses, fittings and couplings
are important for the safety of the machine. Use
only hoses, fittings and couplings recommended
by the manufacturer. (it is extremely important
to protect these components against damage by
avoiding their improper use and protecting them
against bending, knocks and scratches).
22i To ensure machine safety, use only original
spare parts from the manufacturer or approved
by the manufacturer.
Furthermore:
A few fundamental rules common to any
electrically powered machines must also be
observed:
In particular:
- Never touch or start the machine with wet
hands or bare feet;
- Remove the casings and the doors of the
electric boards only once the machine has
been stopped and de-energised;
- Never pull the power cable to disconnect the
plug from the socket.
For fire-prevention purposes:
- Keep all inflammable or combustible products
away from the equipment area.
- Obviously, the above-mentioned instructions
are not sufficient to prevent all sorts of
accidents; therefore, the user will have to be
cautious.
- The machine must not be modified or changed
in any way without the builder's written
authorisation.

SAFETY DEVICE

WARNING: the gun is fitted with a safety catch.
Whenever use of the machine is interrupted it is
important to operate the safety catch to prevent
accidental activation of the jet.
The steam hose connections are equipped with a
double safety block .
- Safety valve
- Safety pressure
switch
- Thermostat

MACHINE DESCRIPTION

This type of generator produces dry and
oversaturated steam at a pressure of 10 bar at a
temperature of 180°C.
Intended and unplanned use
The electric steam generator for industrial cleaning
is used for the cleaning and disinfecting of any
object in an easy and ecological way, also in the
most difficult points with or without detergents.
Any use of the machine other than the one it has
been built for represents an anomalous condition,
can cause serious damages to the operating means
and entail a serious risk for the operator using it.
- The machine has not been built to work in a
place with deflagration risks. It is therefore
absolutely forbidden to use the machine in an
atmosphere with explosion risks.
- For any forbidden use of the machine, the User
must contact the Builder about any possible
counterindications or dangers deriving from
the machine misuse.
- For any modification to be made to the
machine once it has left its building site, the
User must contact the Builder about any risks
the modifications could entail and about their
compliance with the Legislation in force.
Machine handling and transport
The machine is usually packed in cartons on pallets
when delivered.
While unpacking it, check that the machine is
undamaged and that it corresponds to the ordered
one.
Make sure that this operating handbook is included,
that no loosen parts have been forgotten in the
packing and check that the machine has not been
damaged during transportation.
In case of damages, immediately contact both the
forwarding agent and the Builder.
Never leave the packing components (cardboard,
wood, staples, plastic bags, polyethylene sheets,
etc..) in the environment. They must be collected
and delivered to competent organs.
19
EN