THOMSON WEAR8500BT Manual De Instrucciones página 7

5.1. Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
activated.
• For more information, please refer to the operating instructions of your terminal device.
• The earphones and the terminal device should be no further than 1 metre apart. The shorter
the distance, the better.
• Make sure that the earphones are switched off.
• Device off: Press and hold both Multifunction buttons (2) at the same time for
about 3 seconds until a voice says, 'Power on'. After that, the two earphones connect
automatically to one another and a voice says, 'Connected – Right/left channel'. Then
a voice says, 'Pairing' and one of the status LEDs (3) emits ashes of alternating red and
blue light. The earphones are searching for a Bluetooth
• Open the Bluetooth
WEAR 8500 BT appears in the list of Bluetooth
• Select WEAR 8500 BT and wait until the earphones are listed as connected in the
Bluetooth
settings on your terminal device. A voice says, 'Connected'.
®
Note – Bluetooth
Some terminal devices require a password in order to connect to another Bluetooth
• If your terminal device requests a password to establish the connection, enter 0000.
Note
• If pairing was successful, the status LEDs (3) slowly ash blue. A voice says,
'Connected'.
• You can now use the earphones.
5.2. Automatic Bluetooth
Note
• Make sure that your Bluetooth
activated.
• For more information, please refer to the operating instructions of your terminal device.
• Make sure that the earphones are switched on.
• After the devices have been paired, a connection is established automatically. A voice says,
'Power on – Connected – Right/left channel – Connected'.
• You can now use the earphones.
Note
• If pairing was successful, the status LEDs (3) slowly ash blue. A voice says,
'Connected'.
• It may be necessary to change the settings on your terminal device to enable it to
automatically connect to the paired earphones.
4
-capable terminal device is on and Bluetooth
®
settings on your terminal device and wait until
®
password
®
connection (after successful pairing)
®
-capable terminal device is on and Bluetooth
®
connection.
®
devices found.
®
is
®
device.
®
is
®