General Use; Video Output; Safety Instructions - Trust SP-2991BI Manual Del Usuario

USER'S MANUAL
Play iPod Shuffle or other audio device
11 Connect audio cable to Station and to audio output ("headphone") of device.
Press "Aux" on remote control, or press "Mode" on main panel until Aux is selected, see 9.
12 Set volume of audio device to maximum. Use volume control from Station.
iPod navigation and control functions on remote control are not available in Aux mode
Open battery compartment
Push the stop side wards and pull the battery holder out.
13
Place battery as shown in picture (+ side up).
Note

General use

• After turning Station off and on, it will remember last radio frequency and play mode used, but volume will
be set to "06".
• After complete power shut down (or disconnecting and reconnecting power adapter), Station will reset
memory and return to default settings.
• The display shows volume level in "iPod" and "Aux", and frequency setting in "FM" and "AM" play modes.
• Push iPod holder back into Station when dock is not used.
• Wireless range of remote control is at least 10 m.

Video output

• Configure iPod with correct video output settings and connect RCA video cable (not included) to TV, DVD,
VCR etc.
• Video output is only available if iPod model has video output (check iPod specifications), and if the dock
connector is used.
See www.trust.com/15269 for up-to-date FAQs, drivers and instruction manuals. For extensive service, register
at www.trust.com/register.
Energy
• Change remote control battery when performance is decreasing. Only use 3V CR2025 Lithium batteries.
• Never recharge the batteries provided and never throw them onto a fire.
• Observe local regulations when disposing of batteries.

Safety instructions

• Do not open or repair this device.
• Do not use the device in a damp environment. Clean the device with a dry cloth.
2