Publicidad
Step 5
Make equal margins along all four edges of the BACKS (I
å
and J). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACKS (I and J) to your unit using the NAILS (HHH).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the BOTTOMS (G2 and H).
Page 10
These edges must be even.
These holes must line up
over the BOTTOM (H).
J
H
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
I
(29 used in this step)
402375
These holes must line up
over the BOTTOM (G2).
G2
HHH
NAIL
www.sauder.com/services
Publicidad
