Kokido Telsa 80 Manual De Usuario página 15

Detach accessories from the pool vacuum. If necessary, rinse the pool vacuum and
accessories with fresh water. DO NOT use detergent.
Make sure to drain the water from the rear body through the holes located inside
the chamber that connects to the handle/ pole connector, and the hole on the rear
of the body.
Make sure to drain the water from the handle through its hole on the bottom end.
Use a damp cloth to clean and dry the pool vacuum and its accessories.
Store them in a well-ventilated area away from sunlight, heat, ignition sources, pool
chemicals and from children. Ambient temperature for storage should be 10˚C –
25˚C (50˚F – 77˚F). NOTE: A higher storage temperature may reduce the battery
life.
WARNING!
Never attempt in any way to disassemble the pool vacuum.
-
Under no circumstances should you attempt to disassemble the pool vacuum and
-
replace the impeller, motor and battery by yourself.
To replace a damaged wheel, pull/push it out from the cavity. Press the new wheel
-
into the cavity.
CAUTION!
Excessive heat can damage the battery and reduce its lifespan as a result.
The battery supplied with your pool vacuum lasts for about 300 charging cycles
(with proper charging and operation). Life span of battery is reduced if the following
happens:
- Battery appears damaged or will not charge fully.
- Battery operation time is noticeably reduced. Observe and note the
operation time during the first few uses (on a full charge). Use this
information as a reference point to compare operation time with older
batteries.
The battery must be removed from the pool vacuum before it is disposed of.
The pool vacuum must be disconnected from the supply mains while removing the
battery
The battery is to be disposed of safely and according to local ordinances or
regulations.
NOTE: Incorrect maintenance may reduce the battery life and affect its capacity as a
result.
14