STAMOS S-CUTTER 50.1 Manual De Instrucciones página 9

8
GAS / AIR CONNECTION.
GROUNDING:
At the back of each welder there is a screw and a label to provide
9
the necessary grounding. Before operating the unit it is necessary to
ground the shell of the welding apparatus by means of a cable with
not less than 6 mm diameter, in order to prevent potential problems
caused by electricity leakages.
10 ADDITIONAL POWER CONNECTION FOR THE PLASMA TORCH HOSE.
NORMAL CURRENT: plasma cutter S-CUTTER50.1 is supplied from one phase
11
(230V~+/-10%).
1 PH
12 HIGH POWER: cutter S-CUTTER70.1 is supplied from 3-phase mains (400V~+/-
10%).
3 PH
2T/4T SWITCH:
2 / 4 2T – press this button on the burner to start the metal cutting process, release this
T
13
button to end this process.
4T – press this button on the burner to start the metal cutting process, releasing
this button does not end this process. Press and release this button again to end
the metal cutting process.
14
PRESSURE ADJUSTMENT KNOB
15
PRESSURE GAUGE
16
ADDITIONAL PILOT ARC
GAS
17
GAS/OPERATION LIGHT
WORK
EN
Rev. 19.09.2020
16
CONNECTION DIAGRAM S-CUTTER 50.1
1
2
4
3
5
1 – supply connection | 2 – air compressor | 3 – working surface
4 – ground cable connector | 5 – plasma cutting clamp
The yellow-green wire is used as a PE protective wire connector. The three
phases (black) can be freely connected to L1, L2 and L3 (please have it done only
by a qualified electrician).
S-CUTTER 50.1
1 11
15
14
2
13
17
8
6 10 7
Rev. 19.09.2020
EN
CONNECTION DIAGRAM S-CUTTER 70.1
2
4
3
5
S-CUTTER 70.1
5
3
3
17
5
2
8
12
16
6 10 7
17
1
15
13
14
1