Operating Instructions; Operating Tips; Adjusting Tine Depth - Ryobi 510r Manual Del Operador

OPERATING TIPS

WARNING: Dress properly t o reduce the risk
of injury when operating this unit . Do not
wear loose clothing or jewelry. Wear eye and
ear/hearing protection. Wear heavy long pants,
boots and gloves. Do not wear short pants,
sandals or operate barefoot.
1. Move the cultivator to the work area prior to starting
the engine. Transport the cultivator by pushing it on
wheels or carrying it by the handle center tube.
WARNING: To prevent serious personal
injury, never pick-up or carry the unit while
the engine is running.
2. Start the unit by following the Starting Instructions.
3. With the engine running and the tines off the ground,
depress the throttle control to increase the engine
speed.
4. Holding both of the handlebar grips firmly, slowly
lower the cultivator until the tines make contact with
the ground (Fig. 13).
5. As cultivating action begins, tilt the cultivator up
slightly using the handlebars so that the tines can
penetrate the ground.
6. Once the ground has been broken, continue at a
moderate pace until you are familiar with the controls
and the handling of the cultivator.
7. If the tines are digging too deep or not deep enough,
adjust the wheel bracket as described in Adjusting
Tine Depth.
WARNING: To prevent serious personal
injury, u se extreme caution when reversing
or pulling the unit towards you.
12

OPERATING INSTRUCTIONS

Fig. 13

ADJUSTING TINE DEPTH

Tine adjustment will vary depending on the type of soil
being cultivated and how it will be used. Generally, it is
recommended to adjust the tines to break the soil 4 to 6
inches for most gardens. Adjust the tines as follows:
1. Stop the engine and disconnect the plug wire.
2. Loosen (do not remove) the two wing nuts on the
tine guard (Fig. 14).
3. Slide the wheel bracket assembly down for shallower
and up for deeper tine penetration.
4. Once the tines are in the desired position, tighten the
wing nuts, making sure that the carriage bolts are
seated properly through the bracket.
5. If the tine depth is not correct, repeat steps 2 to 4.
Down
Transporting the Unit
WARNING: To prevent serious personal
injury, always stop the engine when
operation is delayed or when transporting
the unit from one location to another.
1. Stop the engine.
2. Slide the wheel bracket assembly all the way down
(Fig. 14).
3. Tilt the unit back until the tines clear the ground.
4. Push or pull the unit to the next location to be
cultivated.
Up
Fig. 14