Single-Wire Connections; Bi-Wire Connections - Pioneer S-3EX Manual De Instrucciones

S-3EX_EN.book 9 ページ ２００７年４月２３日 月曜日 午後５時１２分

Single-Wire Connections

For single-wire connections, connect the mid-to-high- and low-
frequency sections of the crossover network with the shorting link
that was included with this unit, then connect the (+) wire from
your amplifier to either red binding post and the (–) wire from your
amplifier to either black binding post, as shown in below.
Amplifier (rear)
(Only one channel shown) one channel sho n)
Shorting link
connection
HF
LF
Speaker
Speaker (rear): Input panel
SPEAKERS OUTPUT
HF

Bi-Wire Connections

In a bi-wiring connection, you independently plug in the speaker
systems running from the amp to their respective high- and low-
frequency plugs. This results in the CST driver and bass drivers
being independently connected directly to the amplifier, offering
you the freedom to optimize the cable type for each of the drivers.
Connect one set of wires to the bottom set of binding posts (bass
driver-specific network). Then connect a second set of wires to the
top binding posts (CST-specific network). Next, connect both sets
of wires to the appropriate terminals on your amplifier. Take care
to connect both (+) wires to the (+) amplifier terminals and both
(–) wires to the (–) amplifier terminals, as shown below.
Amplifier (rear)
(Only one channel shown)
HF
LF
Speaker
Speaker (rear): Input panel
SPEAKERS OUTPUT
HF
LF
9
En