Configuration; Technical Support - Vaisala HMM170 Guía Rápida

Installing probe
CAUTION!
board at Vaisala. Do not disconnect and reconnect the cable.
1. Remove the yellow protection cap from the probe.
2. Mount the probe head in the selected location using the applicable installation
accessories. See any installation instructions that are delivered with the accessories.
3. Make sure any cable pass-throughs are sealed.

Configuration

To configure HMM170, use Vaisala Insight Software. You can connect the module to Vaisala
Insight software using a Vaisala USB cable (no. 219690).
Download Vaisala Insight software at www.vaisala.com/insight.
More information
For detailed instructions for installing, configuring, and maintaining the module, see HMM170
User Guide (M212259EN) available at www.vaisala.com/hmm170.

Technical support

Contact Vaisala technical support at helpdesk@vaisala.com. Provide at least the
following supporting information as applicable:
• Product name, model, and serial number
• Software/Firmware version
• Name and location of the installation site
• Name and contact information of a technical person who can provide further
information on the problem
For more information, see www.vaisala.com/support.
10
The measurement probe with cable is attached to the component
M212260EN-D