Publicidad
Example:
- PC IP = 192.168.100.001 / Subnetmask = 255.255.255.000
- Print server IP = 192.168.100.002 / Subnetmask = 255.255.255.000
• Select the WLAN communication mode.
- Select 'Ad-Hoc', if you want to operate the print server 'Peer to Peer'.
- Select 'Infrastructure' if you want to operate the print server within a network with an
access point.
• Enter the SSID.
- If you operate the print server in the 'Ad-Hoc' mode, enter a freely definable name.
- If you operate the print server in the 'Infrastructure' mode, enter the SSID of the
access point.
• Select a WLAN security mode and follow the instructions.
5. Verify the settings and click 'Finish' .
The settings are saved and the print server is restarted.
6. Adapt the WLAN settings of the PC to the new print server settings.
7. Choose the 'find new' option in the 'search' menu of the InterCon-NetTool to
find the PS54-G.
If the PS54-G is not listed, print a status page and verify the settings. In the event of
incorrect parameters please reset the print server and repeat the installation. For further
instructions please refer to the 'WLAN-Troubleshooting' section of the Installation Manual.
8. Start the software installation of the print server on the PC.
For further information please refer to the chapter of the Installation Manual dealing with
your operating system.
20
Hardware Installation Guide
Publicidad
