Maintenance - Geotech IM1.1-20 Manual Del Usuario

Oil Water Interface Meter
4.

Maintenance

General
4.1
If the reel and frame need cleaning with water always remove the electronics module in the
reel first by undoing the fixings (F) and sliding out the entire module. NOTE – only clean with
as instructed below.
The battery is accessed by opening the compartment lid (E). NOTE – the operator should
always ensure the correct battery type is fitted at all times, refer 'important notes' section at
the beginning of this manual.
Care of Reel
4.2
If the reel and frame need cleaning with water and always remove the electronic front panel
before washing. The reel may be cleaned with these solutions:
Aliphatics:
Alcohols:
Halogenated
Hydrocarbons:
Others:
Care of Tape and Probe
4.3
The tape and probe can be cleaned and de-greased with the following:
Alcohols:
Aliphatics:
Halogenated
Hydrocarbons:
Others:
Note: Do not clean the tape or probe with abrasives
The probe lens is made from Amorphous Thermoplastic, highly resistant to many chemicals,
but contact should be avoided with:
 Chloroform 1.1.2 Trichloroethane
 Partially Halogentaed Hydrocarbons such as Methylene Chloride, Ketones such as M.E.K.
Phenol (saturated solution).
Geotech (UK) Limited
Hexane
Heptane
White Kerosene
Methyl
Isopropyl
Isobutyl
Freons TF
Freons TE
Soap solution with Naptha Alconox 10%
Most commercially available detergent based cleaning
solutions
Methyl
Isopropyl
Isobutyl
Hexane
Heptane
Fully Halogenated Freon
Soap solution with Naptha Alconox 10%
020365 ISS.07
Page 7