Velleman ZLBL5/2 Guia De Inicio Rapido

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the ZLBL5/2! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
2. Headlight Installation (see fig. 1 – 6)
Fig. 1: Mount the bracket (B) on the handlebars near the stem. Use the
rubber pads (P) to provide another 1-2mm of thickness if
necessary. Tighten the knob (K) to keep the bracket from
rotating
Fig. 2: Slide the headlight into place on the bracket. There should be an
audible click.
Fig. 3: Removing the headlight: press the unlock button (T) and pull the
headlight forward.
Fig. 4: Loosen and remove the bottom screw to replace the batteries or
the bulb.
Fig. 5: Remove the battery cover and mind the polarity indications
when you insert the batteries.
Fig. 6: Remove the bulb ring (R) first, then replace the bulb.
3. Taillight Installation (see fig. 7)
The information in this manual is subject to change without prior notice.
ZLBL5/2
ZLBL5/2 - 3-IN-1 HEADLIGHT + TAILLIGHT
1 VELLEMAN