Program Play - SOUNDMASTER KCD50 Manual De Instrucciones

CD REPEAT
You can repeat a single track or the whole disc.
 In CD mode, press the "REP" button (3) to cycle through the
options of repeat current track, the REP indicator blinks.
 For Repeat all tracks (whole disc), the "REP" indicator will go
stable.

PROGRAM PLAY

For CD disc, you can store a random sequence of up to CD-20 and MP3/WMA- 99 tracks to
play in your preferred order.
To store a program track(s):

In CD Stop mode, press the "PROG" button (4).

Display showing [P01] and "PROG" indicator blinks.
P stand for program and following 2 digits stand for program
number.
 Press the
to program.
 Press the "PROG" button (4) to store this track into the program memory. The track will
be store and the program counter will increase to "P02".
 Repeat the above two steps to store the next and subsequent tracks in your program
sequence.
 When you have finished entering all tracks in your program, press the
start the program playing.
To clear a program
 During program playing, press the
 Open the CD door.
Note: USB program play is same operation.
1. Set the function selector to USB position.
2. Press button (99 to playback the music.
3. The operation procedures are the same as CD playback.
NOTE:
- Compatible storage device (up to 32GB).
- Please do NOT use a USB extension cable to connect your USB flash drive. Such cable can
pick up additional interference which can corrupt the data flow.
- Always connect your USB flash drive directly to the USB port without USB extension cable.
- Due to some USB drive manufacturer's non-compliance with the full USB 1.1/ 2.0 standard. A
small percentage (about 5%) of USB flash drive might not be compatible
button (5 or 8) to select the track number for the first track you want
or
LISTENING TO AN USB
button (10) twice.
4
KCD50 / English Instruction Manual
button (9) to